Knitting the rim with knitting needles is a very specific job, which is necessary for decorating a wide variety of products: from dresses and skirts to shawls and scarves.
Border is called a narrow canvas with a pattern,different from the main part. There are two ways that the rim can be knitted with spokes (the diagrams and the description of each of them have their own specifics). First: several long rows form a longitudinal web. Second: by means of a large number of short rows a transverse rim is formed.
Many models of shawls and scarves have a central (or main) part and a decorative (binding).
In doing this, to perform the main part of the wizardoften use some simple pattern. The main decoration of such products is the strapping, which is knitted in parallel with the central piece or performed separately and then sewed.
Shawl can be any geometric figure:
The openwork fringe, knitted with the needles, is arranged as follows:
Angles (usually, they are equal to 90 degrees) are formed by comparing two stripes of the pattern, the edges of which are cut at an angle of 45 degrees.
Depending on the knitter's skill and the features of the model chosen by her, she can take advantage of one of the three methods of forming corners on a knitted fabric:
Of course, all these tricks are not needed, if youcreate a rim of knitting needles, the scheme and description of which already provides for all the additions and cuts. Many designers provide models with ready-made instructions. Below are the schemes, following which, you can quickly and easily connect the fishnet strip.
The model, the photograph of which is located at the beginning of the article, has a rather dense central part and a beautiful openwork border along two sides.
To form the main part, you need to dial 7 P spokes and mark the central marker.
Then they work as follows:
As a result of tying H, openwork openings will be obtained. If the master wants to avoid such an effect, she should form new P from the broaches between neighboring P.
When the triangle is ready, the edge, which will not be decorated with a border, should be tied with a crochet (several rows of columns without a crochet).
The first scheme, according to which it is necessary to knit the rim,is denoted by A.1. It requires a set of 27 loops to create the first row. The figure shows that the canvas will shrink from the right and expand with the left. As a result, the craftsman will receive the detail for the right side of the shawl.
On the right side of the rim, protruding denticles will also be placed.
Further knitting of the rim with knitting needles will continue according to the scheme A.2. Here already there is a full openwork pattern, a rhombus, and denticles on the right side. Continuing work on the border, you should repeat the rapport pattern A.2.
To form the angle of the master, it is worth turning to A.3. Here is shown the transition from the rim for one side of the shawl to the canvas for the second side.
Further work should be carried out, being guided by the scheme A.4. Repeats repeat the same number of times as the pattern according to scheme A.2.
Complete the knitting of the rim according to the scheme A.5.The openwork strip is ready, now it can be sewn neatly to the triangle connected earlier.
When the knitting is knitted with knitting needles, schemes and descriptionwhich are similar to those given in this article, there may be some run-up in size. In the process of assembling the product, the craftsman can find out that the fringes are denser than the side of the shawl to which they are to be sewn. This defect is easily eliminated by tying the basic details of the shawl.
In the case where the triangle, on the other hand, has too long faces, it should be loosened slightly and the hinges closed again. In other words, some adjustment is required.
In those cases where the openwork fringe is made in parallel with the main part, there is no such problem.